ExtremeRate How to Install Nintendo Switch Lite Replacement Shell - eXtremeRate

🎯 Загружено автоматически через бота: 🚫 Оригинал видео: 📺 Данное видео принадлежит каналу «ExtremeRate» (@ExtremeRate). Оно представлено в нашем сообществе исключительно в информационных, научных, образовательных или культурных целях. Наше сообщество не утверждает никаких прав на данное видео. Пожалуйста, поддержите автора, посетив его оригинальный канал. ✉️ Если у вас есть претензии к авторским правам на данное видео, пожалуйста, свяжитесь с нами по почте support@, и мы немедленно удалим его. 📃 Оригинальное описание: First of all, the installation of Switch Lite replacement shell is difficult if you are a newbie of electronics repair. Especially for the LCD part, you have to heat it up and take it out gently. So anyway this is a risky DIY project for you, but of course it will turn out a stunning result for your Nintendo Switch Lite. GOOD LUCK!! WARNING!!! Do NOT remove any electronic cables without disconnecting the battery first. Shop Links: Amazon US: Amazon CA: Amazon MX: Amazon DE: Amazon UK: Amazon FR: Amazon IT: Amazon ES: Amazon AU: Amazon JP: : Aliexpress: eBay: Timestamps: – Intro – Pre-work Before the Process – Open the Backplate – Remove the Shield and Disconnect the Battery FIRST – Remove the Heat Sink – Lift the Game Card Reader and Headphone Jack – Disconnect the Digitizer and Screen Cable – Remove a Motherboard Screw and Disconnect the Fan – Remove Three Motherboard Screws – Disconnect the Right Joystick Cable – Remove the Right Trigger and Bumper – Remove Remaining Motherboard Screws – Disconnect the Interconnect Cable – Disconnect the Antennas – Disconnect the Battery Cable (WRONG ORDER) – Remove the Motherboard Assembly – Remove the Stock Buttons along with the Membrane – Remove the Right Joystick – Remove Three Daughterboard Screws – Disconnect the Interconnect Cable – Remove Another Two Daughterboard Screws – Disconnect the Joystick Cable – Disconnect the Screen and Volume Button Cables – Remove the Right Trigger and Bumper – Remove the Daughterboard – Remove the Buttons and Membrane – Remove the Left Joystick – Remove the Midframe – Transfer the Thumbstick Dustproof Sheets – Remove the Screen – Reinstall the Screen to the New Shell – Reinstall the Midframe to the New Shell – Reinstall the Thumbsticks to the New Shell – Reinstall the Replacement Buttons along with the Stock Membrane – Reinstall the Daughterboard – Reattach the Ribbon Cables to the Daughterboard – Reinstall the Left Bumper – Reinstall the Left Trigger Assembly – Reattach the Interconnect Cable – Reinstall the