CCYSK: Add A Volume Control To Any Audio Circuit

CCYSK: Add A Volume Control To Any Audio Circuit In this video I answer a question that I have been asked a few times, “How can I add a volume control to my __________?“ This is a simple addition to any audio circuit with a speaker. You simple add in a potentiometer before the speaker. Outer pins of pot go to the signal and ground. The wiper, the middle pin goes to the speaker. You see, all you are doing is bleeding a portion of the signal destined for the speaker to ground. The speaker gets the remaining signal. ************************************************************************* *Please help support this channel at NO COST TO YOU. If you shop on* *Amazon, please use this link: * *I will get a small commission and it costs you nothing. * ************************************************************************* HEY YOU ABOUT TO POST SOMETHING STUPID: Yes, I know my hands are large/fat. It’s because of a heart condition I suffer from called Congestive Heart Failure. Here’s a link to some information about CHF: One of the symptoms is that it causes fluid retention, mostly in the hands, feet/ankles, and face.. ------------------------------------------------------------------------------------------------------------------- Support learnelectronics: Amazon Store: If you are shopping for electronic components, test gear or consumables please consider visiting my Amazon shop @ Patreon: Please check out and pledge a dollar if you can. It will go a long way to keeping the channel alive. It costs a bit of money to buy all the items and produce these videos. Your help is appreciated. Paypal: you’d like to send a one-time donation you can use this link: --------------------------------------------------------------------------------------------------------------------- Gear I use: Multimeter: OWON B33 Oscilloscope: KIPRIM DS1202 Signal generator: Junctek JDS8080 Component Tester: T7 Multifunction Soldering Station: Sealody ???????