I make a Campfire Tripod - Heating Steel Rebar with a Handheld Gas Burner Torch.

I make a Campfire Tripod - Heating Steel Rebar with a Handheld Propane LPG Gas Burner Torch. Because I was using 5/8 inch (16mm) Rebar I needed to use a gas burner torch to heat the steel so I could bend it. I enjoy doing blacksmithing-type jobs, it was a very peaceful DIY project, with nowhere near the amount of noise I normally make. We do quite a bit of outdoor campfire or fireplace cooking and this tripod is a good solid addition to our outdoor kitchen gear. All the rebar was 5/8 inch (16mm) Except the Hook which was made with 1/2 inch (13mm) Rebar. The height of the campfire tripod, when it is set up, is 43 1/2 inches (110mm). Main tools used, were a Handheld Propane LPG Gas Burner Torch, MIG welder, angle grinder, and bench vise. Product Links. The Brand of the cutting/flap discs is “Alpha“ If you can’t get them at your local hardware shop, here is a link to Alpha Tools Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker. Amazon: Milwaukee 4pk Inkzall Black Ultra Fine Point Pens. Amazon: MILWAUKEE 10” Locking Pliers, Curved Jaw, Amazon: ----Filming Equipment used in this video--- 1)Canon EOS M6 Mark II Camera 15-45mm Lens. Amazon: 2)Camera Tripod - Vanguard Alta Pro 2 263AB Tripod with Alta BH-100 Ball Head. Amazon: 3)Camera Microphone - Rode Microphones VideoMicro Compact. Amazon: ►►Subscribe to our Channel for more videos ►► Gavin Clark DIY Hope you found something of use in my video or at least found it entertaining. Always use all the correct safety gear, and use your tools safely, I am not a good role model for this. Note: When you bend metal/rebar, you naturally weaken it. Bending it will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load. DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support! Always use all the correct safety gear, and use your tools safely, I am not a good role model for this. Hope you found something of use in my video or at least found it entertaining. ►►Subscribe to our Channel for more videos ►► Gavin Clark DIY DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support!