FORD FOCUS ST CLUTCH PLATE CLOCK

HOW I MADE THIS FORD FOCUS ST CLUTCH PLATE CLOCK THIS PLATE HAD THE CENTRE HUB RIPPED OUT ALREADY REMOVE ANY SHARP EDGES FROM CENTRE OF BOTH SIDES WEARING A MASK REMOVE ANY STAINS OR LOOSE EDGES FROM CLUTCH LINING YOU DO NOT HAVE TOO, BUT IT DOES LOOK BETTER AFTERWARDS MASK UP AND PAINT CENTRE RETAINING DISC CLEAR COAT THE ENTIRE DISC TO SEAL IN THE CLUTCH LINING DRILL 8mm CENTRE HOLE TO ALLOW CLOCK TO PASS THROUGH EASIER TO START WITH A VERY SMALL DRILL AND WORK UPWARDS PUSH CLOCK SPINDLE IN FROM THE BACK CAREFULLY, LIGHTLY TIGHTEN THE BRASS NUT ONLY ENOUGH TO PINCH AND HOLD IN PLACE OVER TIGHTEN COULD DAMAGE THE GEARING LOOK AT THE CLOCK HANDS CAREFULLY THE RAISED BOSS PART GOES ON THE CLOCK SIDE USING 2 FINGERS EITHER SIDE OF THE HANDS GENTLY PUSH ON ASSEMBLE THE HOUR HAND FIRST, THEN MINUTE, THEN SECOND. ONLY GENTLE PUSH THE SECOND HAND IN, IF YOU EVER WANT TO CHANGE HANDS AT A LATER DATE