Dialing in the Anycubic Kobra Neo 3D Printer - Sponsored by Solderstick Wire Connectors

Dialing in the Anycubic Kobra Neo 3D Printer Get solderstick at 20% OFF with discount code “LE20“ at Anycubic Kobra Neo, Pre-Installed FDM 3D Printer with Direct Drive Extruder High Precision Printing Removable Magnetic Platform with 25-Point LeviQ Leveling, Printing Size 220×220×250mm: In this video I attempt to make well thought out changes to both my new 3D printer and the Cura, the slicing program. Once these two things are tweaked to work together we should get great prints. Also we look at Octoprint () ************************************************************************* *Please help support this channel at NO COST TO YOU. If you shop on* *Amazon, please use this link: * *I will get a small commission and it costs you nothing. * ************************************************************************* HEY YOU ABOUT TO POST SOMETHING STUPID: Yes, I know my hands are large/fat. It’s because of a heart condition I suffer from called Congestive Heart Failure. Here’s a link to some information about CHF: One of the symptoms is that it causes fluid retention, mostly in the hands, feet/ankles, and face.. ------------------------------------------------------------------------------------------------------------------- Support learnelectronics: Amazon Store: If you are shopping for electronic components, test gear or consumables please consider visiting my Amazon shop @ Patreon: Please check out and pledge a dollar if you can. It will go a long way to keeping the channel alive. It costs a bit of money to buy all the items and produce these videos. Your help is appreciated. Paypal: you’d like to send a one-time donation you can use this link: --------------------------------------------------------------------------------------------------------------------- Gear I use: Multimeter: OWON B33 Oscilloscope: KIPRIM DS1202 Signal generator: Junctek JDS8080 Component Tester: T7 Multifunction Soldering Station: Sealody ???????