P-51 Mustang RC Plane Build and Fly

I redesign this RC foam board P-51D Mustang from the original plans that I made for papermodel. I simplify the design for easier building. The main material is still 5mm depron or polyfoam foam board. In this project it’s the first time I use 4 of these new techniques. They are DIY spinner, new clear canopy molding, laminating film for covering and DIY retractable landing gear. I’m quite satisfied with all the result, except the landing gear still needs more improvement but, it has lots of potential. Although it worked but still, I will improve it in future projects. This Mustang is fast, even with just 50% throttle, I was trying hard to not hit a tree when flying it. I should add flaps for slower landing, but the time for this project is limited so I’ll leave it to you to improvise with this plans, good luck and have a good building time. SUBSCRIBE dan Like untuk support channel ini #rcplane #rcmustang #rcwarbird #buildvideo #mustang #warbird You can download the plans on the link below : A4 Plans : A0 Plans : A3 Decal : Build instructions : DONATE via Paypal : Juliusperdana@ Playlist : 00:00 Intro 03:12 Plan Preparation 04:22 Landing Gear 07:32 Wing 14:44 Fuselage 19:06 Spinner 22:27 Installing Motor 23:58 Stabilizers 25:55 Covering 29:26 Wing Mounting 30:24 Tail Section 36:56 Servo and Pushrod 39:51 Color Scheme and Decal 42:15 Clear Canopy 47:42 Finishing Up 49:39 Maiden Flight 58:08 Review Specs : 1. Wingspan 1100mm / 43.3 inches 2. Flying weight : 1060 grams/ 37.4 oz 3. Wing loading : 47.5 gram/dm2 - 15.6 oz/. 4. Wing cube loading : 10 5. Wing Area : 22.3 dm2 / 346 . 6. CG : 4 cm Electronics - motor 35 - 650kv - 1200kv brushless motor - Tested with DXW 3536 1200kv brushless motor prop 10x6x3 - ESC 50A - Battery Lipo 3S 2200mah - 4 metal gear 9 gram servos (micro servo) - 1 metal gear standard servo Materials : 1. 5mm Depron/ Polyfoam 2. 3mm 7mm Plywood 4. Mica Plastic 5. hot glue, UHU glue, CA glue 6. laminating film Tools : 1. Covering iron 2. Heat gun 3. Hot glue gun