F-35A Lightning-II 3D print on ender 3

STL- Taking courage from the popularity of the F-22 Raptor, we finally designed the F-35 requested by so many customers. This F-35 was a real challenge. First, it was relatively small in size. Therefore, the space to design the movable part was limited, so it was very difficult. The second one is very organic and ever-changing in form. So just creating the exterior took a lot of time. The third had many new details. For example, split lines are not hollow, but rather protruding, and zigzag lines are smaller and more complex. It took a lot of trial and error to get these details to look good. Despite these difficult conditions, I was able to express and complete almost all the features of this airplane. However, it may not be easy to print and create for that reason. So, be sure to check the following precautions. ※ Precautions 1. After printing the weapon bay, you need to remove the custom support. After removing it, please refine the surface before assembling it. 2. It is very difficult to connect the cover of the weapon bay. To assemble it more easily, the order is to connect the cover of the weapon bay to the connector first. 3. When connecting the weapon bay to the connector, if you bend the cover with your hand, the gap will widen, making it easier to connect the connector. 4. When connecting the flaps of the main wing, rotate the hinge and insert it into the main wing. Other than that, please refer to the video for more details. If the F-35A gets a lot of support, I will also design the F-35B, so please give me a lot of interest and purchase. 1 : 72 Scale Largest part in printing, size = X 50mm, Y 90mm, Z 105mm, After full assembly size= X 150mm, Y 218mm, Z 64mm Total Build time : 46h 30m / Plastic weight : 157g